Automatic Address Setting - Panasonic CZ-RTC4 Service Manual

4. Auto Address Setting

6. Automatic Address Setting

Automatic Address Setting* from the Remote Controller
*
Automatic address setting in Cooling mode cannot be done from the remote controller.
NOTE
Selecting each refrigerant system individually for automatic address setting
Automatic address setting for each system
: Item code "A1"
1
1 Press the remote controller timer time
button at the same time.
(Press and hold for 4 seconds or longer.)
2 Next, press either the temperature setting
button. (Check that the item code is "A1.")
3 Use either the
perform automatic address setting.
4 Then press the
(Automatic address setting for one refrigerant system
begins.) (When automatic address setting for one
system is completed, the system returns to normal
stopped status.)
<Approximately 4 – 5 minutes is required.>
(During automatic address setting, "
displayed on the remote controller.
This message disappears when automatic address
setting is completed.)
5 Repeat the same steps to perform automatic address
setting for each successive system.
button and
/
button to set the system No. to
button.
" is
2
4
1
1 - 14
Optional Controller
Remote Controller Functions
4
3
CZ-RTC4