DeWalt DW430 Manual page 19

Follow the instructions for maintenance and
changing accessories. Inspect the tool cords at
regular intervals and, if damaged, have them
repaired by an authorized D
Inspect the extension cords periodically and
replace them if damaged. Keep all controls dry,
clean and free from oil and grease.
19 Check for damaged parts
Before using the tool, carefully check it for
damage to ensure that it will operate properly
and perform its intended function. Check for
misalignment and seizure of moving parts,
breakage of parts and any other conditions that
may affect its operation. Have damaged guards
or other defective parts repaired or replaced as
instructed. Do not use the tool if the switch is
defective. Have the switch replaced by an
authorized D WALT repair agent.
E
20 Have your tool repaired by an authorized
D WALT repair agent
E
This Power Tool is in accordance with the
relevant safety regulations. To avoid danger,
electric appliances must only be repaired by
qualified technicians.
Sanding paint
Observe the applicable regulations for sanding paint.
Pay special attention to the following:
1 Whenever possible, use a vacuum extractor for
dust collection.
2 Take special care when sanding paint which is
possibly lead based:
• Do not let children or pregnant women enter
the work area.
• All persons entering the work area should wear
a mask specially designed for protection
against lead paint dust and fumes.
• Do not eat, drink or smoke in the work area.
3 Dispose of dust particles and any other removal
debris safely.
Package contents
The package contains:
1 Belt sander
1 Dustbag
1 Instruction manual
1 Exploded drawing
14
WALT repair agent.
E
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your D WALT belt sander DW430/DW431 has been
E
designed for professional applications.
1 On/off-switch
2 Speed control dial (DW431)
3 Lock-on button
4 Clamping spring (for sanding frame)
5 Sanding belt
6 Belt centring knob
7 Dustbag
8 Grip
9 Roller shaft
10 Roller
11 Locking shaft holder (for sanding frame)
12 Clamping lever
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualified electrician.
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs.
Attach the wires to their respective points in the
plug (see below). Brown is for Live (L) (2) and
Blue is for Neutral (N) (4).
E N G L I S H
en - 3