Oldsmobile 2003 Bravada Owner's Manual page 105

Reprogramming a Single HomeLink@
Button
To program a device to HomeLink@ using a HomeLink@
button previously trained, follow these steps:
1 . Press and hold the desired HomeLink@ button. Do
2. The indicator light will begin to flash after
not release the button.
20 seconds. While still holding the HomeLinkO
button, proceed with Step 2 under "Programming
HomeLinka ."
Resetting Defaults
To reset HomeLink@ to default settings do the following:
1. Hold down the two outside buttons for about
20
seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink@
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink@ at
1-800-355-3515, or on the internet at
www.homelink.com.
2-40