Sunroof - Chevrolet 2008 Avalanche Owner's Manual

Reverse the procedure to reinstall the tonneau cover
using the following suggestions:
•
When reinstalling the front rail, start by holding the
back edge of the rail up and then twisting the back
edge down while pushing it into place.
•
Both bows are the same size and therefore
interchangeable.
•
When placing the bows in the side rails, it is easiest
to place the spring-loaded bow end in first.
•
When reinstalling the tonneau cover, start at the
front, near the cab. Place the plastic lip into the front
rail, then the rear rail, and finish with the side rails.
To clean the tonneau cover, use mild soap and water.
If necessary, use a soft bristle brush to remove dirt
trapped in the grain of the material.
2-96
•
When placing the bows,
locate the small notches
in the side rails. These
notches receive the tang
on the bow ends and
help the bows seat into
place.

Sunroof

Your vehicle may be equipped with a power sliding
sunroof. To open or close the sunroof, the ignition needs
to be turned to ON, or Retained Accessory Power (RAP)
must be active. When RAP is active, the sunroof will work
for 10 minutes after the ignition is turned off, or until a
front door is opened. See Retained Accessory Power
(RAP) on page 2-32 for more information.
Manual-Open/Manual-Close: To open the sunroof
press and hold the rear of the driver's side switch until
the sunroof reaches the desired position. To close the
sunroof, press and hold the front of the driver's side
switch until the sunroof reaches the desired position.
The sunshade will open automatically with the sunroof,
but can also be opened manually.
There are two switches in
the overhead console that
operate the sunroof.