Before You Begin; Assembly And Set-Up - Razor crazy cart shift Owner's Manual

BEFORE YOU BEGIN

TURN POWER SWITCH OFF BEFORE CONDUCTING ANY ASSEMBLY OR MAINTENANCE PROCEDURES.
Remove contents from box. Remove the separators that protect the components from damage during shipping. Inspect
the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping.
Because the Crazy Cart Shift was 99 percent assembled and packed at the factory, there should not be any problems,
even if the box has a few scars or dents.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 5 minutes for assembly, not including initial charge time.
Allow up to 12 hours for initial charge.
Charger
(Note: Charger design may vary
from one shown)
2.
Steering Wheel
Speed Control/
Accelerator Pedal
1.
Charger Port
ASSEMBLY AND SET -UP
Attaching the Flag
1
Locate the hole on the top left
side of the product. Insert flag.
On/Off Switch
Stabilizing Posts
3
WARNING:
DO NOT USE NON-RAZOR PARTS
WITH YOUR CRAZY CART SHIFT.
The Crazy Cart Shift has been
built to certain Razor design
specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame and
all other parts. Certain aftermarket
components may not be compatible.
Use of non-Razor parts will void the
warranty.
Product ID Locations:
1. Front of frame
2.
3. Charger
4. Box (not shown)
WARNING:
Turn power switch to OFF before
conducting any assembly or
maintenance procedures.
Plastic Bag Contents:
• Charger
• Owner's Manual
WARNING:
Failure to properly tighten the
steering bolt may allow the steering
wheel to dislodge while riding and
may cause you to lose control.