Display - Panasonic KX-FP181E Operating Instructions Manual

Display!

If the unit detects a problem, one or more of the following messages will appear on the display.
Display message
CALL SERVICE
CALL SERVICE2
COVER OPEN
CHECK FILM
CHECK DOCUMENT
CHECK MEMORY
CHECK PAPER
EASY DIAL FULL
FAX IN MEMORY
FAX MEMORY FULL
There is something wrong with the unit. Contact our service
personnel.
The covers are open. Close them.
The ink film is empty. Replace the ink film with a new one
(p. 83, 84).
The ink film is not installed. Install it (p. 83, 84).
The ink film is slack. Tighten it (see step 6 on page 84).
The document is not fed into the unit properly. Reinsert the
document. If misfeeding occurs frequently, clean the document
feeder rollers (p. 82) and try again. If the problem remains, adjust
the feeder pressure (p. 81).
Memory (telephone numbers, parameters, etc.) has been erased.
Re-program.
The recording paper is not installed or the unit has run out of
paper. Install paper and press
The recording paper is not fed into the unit properly. Reinstall
paper (p. 11) and press
The recording paper has jammed near the recording paper
entrance. Clear the jammed paper (p. 80) and press
clear the message. Do not install folded or heavily curled paper.
There is no space to store new stations in the EASY DIAL
directory. Erase unnecessary stations (p. 22).
The unit has a document in memory. See the other displayed
message instructions to print out the document.
Memory is full of received documents due to a lack of recording
paper or a recording paper jam etc. Install paper or clear the
jammed paper.
When performing memory transmission, the document being
stored exceeds the memory capacity of the unit. Transmit the
entire document manually.
Error Messages
Cause & Remedy
to clear the message.
SET
to clear the message.
SET
to
SET
73