Table of Contents
Advertisement
FMTuner
Frequency Range: 87.5- 107.9MHz
Usable Sensitivity: Less than 10dB at S/N 30dB
Stereo Separation: >30dB(1 kHz)
Signal/noise ratio:
>55dB
AM Tuner
Frequency Range: 530 -1710KHz
Usable Sensitivity: Less than 40dB
MP3/WMA mode
MP3 sampling rate: 32kHz, 44.1 kHz, 48kHz
MP3 bit rate:
8-320kbps and varibale bit
WMA bit rate:
Logical format:
Number of file:
Max directory
depth:
Sorting Method:
Max File/Directory
Name:
ID3 tag:
USB
rate
8-320kbps
IS09660, Joliet
Maximum 999
10
Tree sorting
64Byte
V2.0 or later
USB Host:
Host 1.1 compatibles 2.0
Maximum memory capacity:
32GB
Playable folders:
up to 99
Playable files:
up to 5000
SD
Maximum memory capacity:
Playable folders:
Playable files:
8
FZ105
32GB
up to 99
up to 5000
General
Power Supply Voltage: 12V DC (10.8 to 15.6V),
Fuse:
Speaker Impedance:
Power output:
Aux-in level:
Negative Ground
15A
4-8 ohms per channel
45W x 4 channels
~650mV
Note: Specincations and design are subject to
change without notice for further improvement
Power Output: 14 Watts RMS x 4 Channels
at 4 Ohms and 1% THD+N
Signal to Noise Ratio: 60 dBA
(reference: 1 Watt into 4 Ohms)
1. Before Starting
1. This set is exclusively for use in vehicles with
a negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery " _ " terminal
before starting. This is to prevent short circuits
during installation. (Figure 1)
2. General Cautions
Battery
Figure 1
1. Do not open the case. There are no user serviceable parts inside. If you drop anything into the unit
during installation, consult your dealer or an authorized
Clarion
service center.
2. Use a soft, dry cloth to clean the case. Never use a rough cloth, thinner, benzine, or alcohol etc.
For tough dirt, apply a little cold or warm water to a soft cloth and wipe off the dirt gently.
3. Cautions on Installation
1 .
Prepare all articles necessary for installing the
source unit before starting.
2. Install the unit within 30° of the horizontal
plane. (Figure 2)
3. If you have to do any work on the car body,
such as drilling holes, consult your car dealer
beforehand.
Figure
2
4. Use the enclosed screws for installation. Using
other screws can cause damage. (Figure 3)
Chassis
Chassis
tt~~~age
Max. 6 mm (M5 screw)
Figure 3
Advertisement
Table of Contents
