Contents 1. FEATURES Thank you for purchasing this Clarion product. • Please fully read this owner’s manual before operating this equipment. • Front USB Input and Front Panel Auxiliary Input • Check the contents of the enclosed warranty card and store it in a safe place with this manual.
If a problem should occur, have the unit When the memorized data is lost or that trouble arises, never open the case, inspected at your store of purchase. damaged by any chance, Clarion shall disassemble the unit, or lubricate the 531-1629kHz 87.5-108MHz not be liable for any damage.
DSP in system menu) RESET Button • BAL: 9L-1L -> 0(Centre)-9R Note: • FADER: FADER: 9R-1R -> 0(Centre)-9F Doing the operation above again or adjusting volume will release muting. FZ003A...
2. The unit has 4 bands, such as FM1, FM2, Manual tuning device. Close the cover of USB connector. FM3 and AM. Each band can store 6 During manual tuning, the frequency will be stations, FZ003A can store 24 stations in Pausing play changed in steps. Folder Select total.
Speaker is shorted. Check wiring and correct. connector plugged into audio-in socket on the front panel on the left of USB slot. Unit resets itself Incorrect connection between when engine Check wiring and correct. ACC and Battery. is off. FZ003A...
Specification: USB 1.0/2.0 to change without notice for further Playable audio format: MP3(.mp3): MPEG 1/2/Audio Layer-3 improvement. WMA(.wma): Ver 7/8/9.1/9.2 Audio Amplifier Maximum power output: 180W (45W x 4) Speaker impedance: 4Ω (4 to 8Ω allowable) Input Aux-in level: ≤2V FZ003A...
Source unit .......... 1 Wire connector ........1 Owner’s manual........1 Trim ring ..........1 Clarion dealer for details. Mounting bracket ......... 1 Strap ............ 1 2. Fasten the front stopper securely to prevent the source unit from coming loose.
Attach the trim ring around the front panel. Screwdriver Mounting bracket Spring Stoppers Trim ring Note: Before attaching the mounting bracket, slightly bend the spring toward the inside with your fingers and attach it to the side of car. FZ003A...
Blue wire (Amplifier and Anttena turn-on lead) Front Right Gray/Black Connect to remote turn-on lead of amplifier and power supply terminal for antenna White Front Left Black wire (Ground lead) White/Black Purple Connect to vehicle chassis ground Purple/Black Green Not used. Green/Black Insulate each wire FZ003A...
Need help?
Do you have a question about the FZ003A and is the answer not in the manual?
Questions and answers