Before Requesting Service - Panasonic NN-CD997S User Manual

Before requesting Service

The oven causes
interference with my TV.
Steam accumulates on the
oven door and warm air
comes from the oven vents.
I accidentally operate my
microwave oven without
any food in it.
There are humming and
clicking noises from my
oven when I cook by
Combination.
The oven has an odor and
generates smoke when
using the Convection,
Combination and Grill
function.
PrOBlEM
Oven will not turn on.
Oven will not start cooking.
The words "DEMO MODE"*
appear on the screen.
When the oven is turning on,
there is noise coming from
Ceramic Tray.
* DEMO MODE is designed for retail store display.
Cooking and other functions will not operate during demo mode.
If it seems there is a problem with the oven, contact an authorized Service Center.
all tHESE tHIngS arE nOrMal:
Some radio and TV interference might occur when you cook with the
microwave oven. This interference is similar to the interference caused by
small appliances such as mixers, vacuums, hair dryers, etc. It does not
indicate a problem with your oven.
During cooking, steam and warm air are given off from the food. Most of the
steam and warm air are removed from the oven by the air which circulates in
the oven cavity. However, some steam will condense on cooler surfaces such
as the oven door. This is normal.
Operating the oven empty for a short time will not damage the oven.
However, we do not recommend this to be done.
These noises occur as the oven automatically switches from microwave
power to Convection, to create the Combination setting. This is normal.
It is essential that your oven is wiped out regularly particularly after cooking
by Combination or Grill. Any fat and grease that builds up on the roof and
walls of the oven will begin to smoke if not cleaned.
POSSIBlE caUSE
The oven is not plugged in
securely.
Circuit breaker or fuse is tripped or
blown.
There is a problem with the outlet.
The door is not closed completely.
Start Pad was not pressed after
programming.
Another program has already been
entered into the oven.
The program has not been entered
correctly.
Stop/Reset Pad has been pressed
accidentally.
Timer/Clock Pad has been pressed
4 times.
The roller ring and oven bottom are
dirty.
- En-5 -
rEMEdY
Remove plug from outlet, wait
0 seconds and re-insert.
Reset circuit breaker or replace
fuse.
Plug another appliance into the
outlet to check if the outlet is
working.
Close the oven door securely.
Press Start Pad.
Press Stop/Reset Pad to cancel
the previous program and
program again.
Program again according to the
Operating Instructions.
Program oven again.
Deactivate mode by pressing
Timer/Clock Pad 4 times.
Clean these parts according to
Care of Your Microwave Oven
(See next page).