Alarm; Motion - Night Owl HDA SERIES User Manual

7.1.4 Alarm

a. Motion: configure the motion alarm settings for your DVR system.
Channel: select the channel to configure motion alarm settings.
Enable: activate motion alarms.
Sensitivity: adjust the level of motion detection. A lower setting will require more
movement in the camera range to begin recording.
Buzzer: toggle between ON and OFF to enable an audible alert from the DVR.
Post Recording: set the amount of time to record after the motion is detected. You
can select between 30 and 300 seconds.
Area: clicking Setup will allow you to configure areas which will and will not
detect motion. Red boxes denote areas that will detect motion and uncolored
boxes show areas that will not. When finished, right click to go back to menu.
Show Message: check the box to enable the display of a red "M" on-screen while
in Live View mode. "M" means motion is occurring.
Send Email: check the box to send an email alert when motion is detected. See
section 7.1.3. for email setup and configuration.
Full Screen: when this box is checked, the selected channel will go to full screen
when motion is detected.
Push: selecting this tick box will enable push notifications to your mobile device
when motion is detected in the selected channel. The default setting is on.
Record Channel: this option gives you the ability to start recording on the
channels you select/highlight as soon as motion has been detected on the Channel
selected above within the Channel field.
Chapter 7: Menus and Settings 41