License Plate Lamp - Chevrolet 2011 Impala Owner's Manual

10-36 Vehicle Care
To replace one of these bulbs:
1. Open the trunk. See Trunk on
page 2 10.
2. Remove the convenience net
(if equipped). Unhook the net
from the upper wing nut.
3. Turn the upper wing nut
counterclockwise and remove it.
4. Pull the carpet away from the
rear of the vehicle.
5. Turn the two hex nuts
counterclockwise to
remove them.
6. Pull out the taillamp assembly
and disconnect the wiring
harness.
7. Turn the bulb socket
counterclockwise to remove it.
8. Pull the old bulb straight out to
remove it.
9. Push the new bulb straight in
until it clicks to install it.
10. Reverse steps 1 through 7 to
reinstall.

License Plate Lamp

To replace one of these bulbs:
1. Turn the lamp assembly
counterclockwise and pull
the lamp assembly out of the
connector.
2. Pull the old bulb from the lamp
assembly, keeping the bulb
straight as you pull it out.
3. Install the new bulb.
4. Reverse Steps 1 through 3 to
reinstall the license plate lamp.