Circuit Diagram; Wiring Diagram - Makita BTM40 Technical Information

C
ircuit diagram
Fig. D-1
Color index of lead wires' sheath
Black
Red
White
Battery capacity warning lamp
Terminal
Line filter*
* Line filters are not used
for some countries.
W
iring diagram
Fig. D-2
Connecting Controller with Terminal
Each Flag terminal must be so connected with
Terminal that its wire connecting portion
is located over the pole marking of Terminal.
wire connecting
portion
Flag terminal
Terminal
Blue
Yellow
Dial
Controller
Connector of Controller unit
Fig. D-3
pole marking
The electrical parts and wires indicated
by the gray shaded area are component
parts of Controller unit.
Controller unit
Switch
Connecting Controller with Switch
[Correct]
Insulated terminals must be
so connected with Switch
that the Lead wires are placed
on Switch tumbler side.
Insulated terminal
Switch
Switch tumbler
red dot marking
DC Motor
Line filter*
LED Light circuit
Connector of
LED Light circuit
[Wrong]
If connected as shown below,
Lead wires interfere with
Handle cover.
Switch
P 8/10