Craftsman 137.212372 Operator's Manual page 28

TURNING LASER TRAC
1. To turn laser on, press on/off rocker
switch (1) to "ON" position.
2. To turn laser off, press on/off rocker
switch (1) to "OFF" position.
Fig. U
ALIGNING THE LASER TRAC
The laser line must always be correctly
aligned with the blade to ensure
straight, even cutting. Your tool is
equipped with the Laser Trac
guide using Class IIIa laser line. The
laser line will enable you to preview the
saw blade path on the stock to be cut
before starting the miter saw. This laser
Trac is powered by the transformed
®
alternating current supply directly
through the power lead. The saw must
be connected to the power source
and the laser on/off switch must be
turned on for the laser line to show.
WARNING
!
● To prevent serious injury, insert a
padlock (not provided) or chain with
padlock through the hole in the ON/
OFF Trigger Switch prior to making
any laser adjustments.
ON (FIG. U)
®
1
®
cutting
®
28
● Do not remove the lock from the
ON/OFF trigger switch during any
laser adjustments.
AVOID DIRECT EYE CONTACT
(FIG. V)
WARNING
!
● Laser radiated when Laser Trac
is turned on. Avoid direct eye
contact.
● Laser Warning Label:
Max. Output < 5 mW Wavelength:
630-660nm, Complies with 21
CFR 1040.10 and 1040.11. Class
IIIa Laser Product. (FIG. V)
● Laser Aperture Label: AVOID
EXPOSURE: Laser radiation is
emitted from this aperture.
(Fig. V)
● NOTE: All the adjustments for the
operation of this machine have
been completed at the factory.
Due to normal wear and use,
some occasional readjustments
may be necessary.
● CAUTION: Use of controls or
adjustments or performance of
®