Objecto T3 User Manual page 9

4. Once the desired temperature is displayed, simply stop pressing the
button (remote control
from a flashing mode to a solid one.
5. When the temperature in the room drops below the set temperature, the
heater starts working and stops only when it reaches the set temperature.
* The built in sensor detects the room temperature which surrounds the water.
6. Pressing the power button
the remote control turns the heater off.
7. Turn the power switch off and unplug the cord.
Using the shutdown timer.
1. While the heater is operating, pressing the OFF-timer button
(remote control
(1hr.) (2hrs.)
2. The heater display starts flashing.
3. The length of time changes each time you press the timer button. You can
set the timer for up to 4 hours in 1-hour increments.
To cancel the timer, press until it reaches --.
Once you made the setting, wait about 10 seconds for the flashing light to change to solid.
While using the heater with the timer working, you can still switch the operating mode, set the
temperature to Auto or change the time on the timer.
4. While the heater is operating, after you set the timer, and time advances,
the time remaining on the timer is displayed.
(4hrs. left) (3hrs. left)
・ When operating in the AUTO mode, the display alternates between the time
set for the timer and the temperature setting.
・ When operating in the LO (low) or HI (high) modes, the timer setting is
displayed continuously.
To cancel the timer
Press the
shows --.
). After about 10 seconds, the displays switches
) to set the time to shut off.
(3hrs.) (4hrs.)
(2hrs. left) (1hr. left)
OFF-timer button (remote control
on the unit or the OFF button
(Cancel)
(Off)
9
English
ZZZZBBBBMM mmmm
BBBBbbbbb
heater.
&&&&BBBB@* WWW
on
) until the display