Objecto T3 User Manual page 14

Check the following before Requesting Repair or Service
Problem
The power does not
turn on.
It stopped working
It smells
Buttons do not
respond
The heater makes a
rattling sound when
moved.
There are clicking
and buzzing noises
during use
Heater does not get
hot
The remote control
does not work
Primary cause
• The power cord is not
plugged into the outlet.
• Not located in a flat
stable location (tip over
switch activated).
• Safety equipment
(thermal-fuse) is
activated (See page 6).
• Safety equipment
(thermal-fuse) is
activated (See page 6).
• Turned off by the
thermostat (See Page 6).
• Turned off by the timer.
• Stopped by the auto
switch-off function.
• The heater may have a
new product smell due
to its internal coating.
• The child lock is
engaged.
• Sound from the tip over
switch.
• The noises are from
electrical current and
expansion/contraction
of the heater.
• Operating in LO (low)
mode, or if in AUTO,
the set temperature is
lower than the room's
temperature.
• Is the battery worn out?
• The terminals +/- of the
battery are reversed.
• Using it outside the
reception range of the
remote.
• The child lock is
engaged.
Solution
Plug the power cord into the outlet.
Check the location and locate the
unit in a flat, stable location.
Contact the sales outlet.
Contact the service center.
Press the Reset button on the rear.
Press the power button
again.
Once 12 hours elapses the unit will
shut off automatically, so press the
power button again.
The smell will disappear with use.
Cancel the child lock (see page 10).
This is normal.
This is normal.
Make the AUTO setting higher than
the room's temperature.
Put a new battery in the remote.
(The battery that come with is for
checking operation of the remote.
Insert a new battery.)
Check the battery terminals +/- and
put it in correctly.
Get closer to and at an angle to the
receiver on the unit so it works.
Cancel the child lock (see page 10) .
14
English