Leg Assembly - 3DR DIY Y6 Build Manual

5 Leg assembly

Follow these instructions to assemble
one leg.
1 Assemble leg
Align the leg plates, and place a
standoff between each of the bottom
three pairs of holes in the plates.
Secure each standoff to the plates
with a 5 mm bolt on each end. Insert
the support plate into the horizontal
slots at the top of the leg.
2 Attach leg to arm
Align the two holes in the top of the
leg with the two holes in the center of
the arm. Orient the leg with the point
facing towards the center of the
copter. Insert two 25 mm bolts
through the arm and the leg, and
secure with metal nuts.
Repeat these steps for each leg of
your copter.
leg plates (2) leg support plate 5 mm bolts (6)
18 mm spacers
5 mm bolts
metal nuts
18 mm female-to-female 25 mm bolts (2)
threaded stando s (3)
leg support plate
5 mm bolts
25 mm bolts
metal nuts (2)
21