Putting Into Operation; Working Instructions - Bosch GBH 36 V-LI Operating Instructions Manual

gbh36v_bu_1619929686_t.fm Seite 7 Freitag, 17. März 2006 10:14 10

Putting into Operation

Inserting the Battery
Use only original Bosch lithium-ion batteries with
the voltage given on the nameplate of the power
tool.
Place the right/left switch 7 in the middle position to
protect the power tool from being unintentionally
switched on. Slide the charged battery 16 from the
front into the foot of the power tool. Press the battery
16 completely into the foot until the red stripe can no
longer be seen.
Set the Operating Mode
With the operating mode selector switch 10, select the
operating mode of the machine.
Change the operating mode only when the ma-
chine is switched off! Otherwise, the machine can
be damaged.
To change the operating mode, press the locking but-
ton 9 and turn the operating mode selector switch 10
to the desired position until it can be heard to latch.
For hammer drilling in concrete and stone
For drilling in steel or wood, for driving
screws and cutting threads
For adjusting the chiselling position
(Vario-Lock)
For chiselling
Setting the Direction of Rotation (see Fig.
With the right/left rotation switch 7, the rotational di-
rection of the machine can be changed.
Change the direction of rotation only when the
machine is switched off! Otherwise, the machine
can be damaged.
Right rotation:
Press the right/left switch 7 to the left to the stop.
Left rotation:
Press the right/left switch 7 to the right to the stop.
Always set the direction of rotation for hammer drilling,
drilling and chiselling to right rotation.
1 619 929 686 • (06.03) T
Switching On/Off
To switch on the machine, press the on/off switch 8.
When the machine is switched on for the first time, a
starting delay can occur since the electronics of the
machine must first configure itself.
To switch off the machine, release the on/off switch 8.
Speed Regulation
By increasing or decreasing the pressure on the on/off
switch 8, the speed of the switched-on machine can
be continuously regulated.
Reduced speed of the machine facilitates the starting
of holes (e.g., on smooth surfaces such as tiles), pre-
vents the slipping of the drill and the splintering of the
drilled hole.
Recommended Speed Ranges:
– High speed for hammer drilling in concrete or stone
as well as for chiselling
– Medium speed for drilling in steel and wood
– Low speed for driving screws and cutting threads.

Working Instructions

Chiselling
The SDS-plus tool can be turned in the tool holder to
various positions to achieve an optimum and low-fa-
tigue working position.
Turn the operating mode selection switch 10 to posi-
tion (Vario-Lock). Then turn the tool in the tool hold-
er to the desired position.
For chiselling, turn the operating mode selection
switch 10 to position
Set the direction of rotation for chiselling to right rota-
tion.
Screw Driving (see Fig.
Place the machine on the nut/screw only when it
is switched off.
To use screwdriver bits, a universal holder with SDS-
)
N
plus shaft 32 (accessory) is required.
Clean the adapter shaft and lightly grease the insertion
end before inserting.
Insert the universal holder 32 with a twisting motion
into the tool holder 3 until it locks.
The universal holder locks itself. Check the locking by
pulling on the universal holder.
Insert a screwdriver bit into the universal holder.
To remove the universal holder 32, pull the locking
sleeve 5 to the rear, hold it in this position and remove
the universal holder from the tool holder.
English–7
. This locks the tool.
)
O