Table of Contents
Advertisement
ENVR8304D-8CH
2.
Installation
2.1 Hard Disk Drive Installation
1. Make sure the NVR is power-off.
2. Unscrew the ten housing screws on the NVR, and open the housing.
3. Screw two HDD brackets on both sides of the HDDs using the Sliver Screws.
Silver Screw
HDD Bracket
4. Use the SATA Cable, and connect one end to the SATA port on the small PCB inside the
NVR, and the other end to the SATA port on the HDD.
5. Connect the internal power cable to the HDD.
7
Advertisement
Table of Contents
