Operation; Preliminary Procedure; Transmission & Reception - Omnicom RS-5100 Owner's Manual

OPERATION
1. PRELIMINARY PROCEDURE
Ascertain that the power and antenna cables are properly connected. Set the CB/PA Switch to the "CB" position
and the Squelch Control to the full counterclockwise position. Then proceed as follows:
(1)
Insert the microphone plug into the MIC Socket.
(2) Rotate the OFF/Volume Control clockwise until a click is heard.
This turns the power on and illuminates the Signal/Power Meter.
(3)
Rotate the OFF/Volume Control further clockwise for suitable volume so that the rushing noise from the
speaker can be heard clearly.
(4) Slowly rotate the Squelch Control clockwise until the noise from the speaker suddenly disappears and then
set the control there. This is the position at which optimum squelch effects can be obtained.
2.
TRANSMISSION & RECEPTION
CAUTION: DO NOT PUSH THE PRESS-TO-TALK BUTTON ON THE MICROPHONE WITHOUT CONNECTING
AN ANTENNA.
(1) Set the switches and controls as follows:
Delta Tune Switch
Center position (NOM)
ANL Switch
ANL (ON) position
CB/PA switch
CB position
Squelch Control
As described under the item "Preliminary Procedure"
(2)
Connect the microphone and set the Channel Selector to the desired channel as indicated directly on the
selector knob.
(3)
Turn the power on and adjust the loudness of speaker.
(4)
To transmit push and hold the press-to-talk button on the microphone.
Hold the microphone about 5cm from your mouth and speak in a normal tone of voice.
—5—