Installation; Antenna Connection; Power Connection - Omnicom RS-5100 Owner's Manual

MOUNTING BRACKET
SPACER x 2
WASHER x 2
-------- TAPPING SCREW x2
TOOTHED LOCK WASHER .2
WING BOLT x 2
INSTALLATION
A suitable place for installing the unit is under the dash of your car.
Installation is not complicated; it can be done by simply using the
supplied pre-drilled mounting bracket and complete set of screws and
nuts (see illustration for details). When choosing a mounting position,
be sure to observe the following precautions:
(1)
Avoid places in the vicinity of air conditioning or heating system
openings.
(2)
Installing place should be free from moisture and dust.
(3)
To ensure interference-free driving of car and for convenience of
operation, allow a proper spacing between the unit and the
driver's seat.
(4)
The unit should be installed where there is no direct transmittal
of vibrations. It should be either secured in position or held
with proper suspension springs.
ANTENNA CONNECTION
Antenna to be used should be of a type conforming to the FCC Regulations. Connect the antenna cable into the standard
"M" type ANT Socket provided on the rear of the unit. Proper antenna installation should be referred to the instruction
manual included with your antenna.
POWER CONNECTION
The power cable is color-coded to indicate polarity. Connect the red lead to the positive (+) post of a 12V car-battery
and the black lead to the negative () post. The unit permits connection to either negative or positive ground system
battery without requiring modifications.
Note: * Before making connection, ascertain that the OFF/Volume Control is in the extreme counterclockwise position
(power OFF).
* Be very careful not to connect the cable in wrong polarity. Wiring in wrong polarity will blow out the fuse (2A)
in the cable.