Operating Parts - Omnicom RS-5100 Owner's Manual

OPERATING PARTS
1. MIC Connector
For connection of the supplied press-to-talk microphon e.
2.
Delta Tune Switch Retunes the receiver in the input frequency when it cau ses drifting during reception.
3. ANL Switch
Automatically reduces external electrical noise, such as pulse or ignition noise
introduced in receiving signals.
4. CB/PA Switch PA position is used only for public-address operation. For normal operation this
switch should be set to CB position.
5. Squelch Control
Functions only in the receive mode. It silences the speaker while the signals are
absent and allows a quiet standby operation.
This control does not affect the receiver volume when signals are present.
6.
On-air Lamp This lamp keeps lighting while the transmitter is in operation.
7. OFF/Volume Control . . . . This control has two functions; power ON/OFF and receiver volume adjustments.
8. Signal/Power Meter
A dual purpose meter which indicates relative output power during transmission and
input signal strength during reception.
9.
Channel Selector Tunes the transmitter and receiver simultaneously in any of 23 channel frequencies.
10. ANT Socket For connection of antenna cable.
11. EXT SP Jack For connection of an external speaker.
This connection automatically shuts off the built-in speaker.
12. PA SP Jack For connection of a public-address speaker.
13. Power Cable This cable should be connected to a 12V car-battery or an AC-DC converter.
—3—