Table of Contents
Advertisement
Configuration and procedure
ISP (In System Program) software
the firmware of CPU.
It is a DOS-based program, which cannot be run in MS-Windows.
ISP cable
is for the interface between "Parallel Port of PC" and
"15 pin-D-SUB connector of Monitor".
System and equipment requirements
1.
An i486 (or above) personal computer or compatible.
2.
Microsoft operation system Windows 95/98
DOS environment
=>
.
3.
ISP Software
4.
ISP Cable (3138 106 10148) as shown in Fig. 1
Fig. 1 => ISP CABLE : 12nc is "3138 106 10148".
Step 1 : Make a folder in your PC as shown in Fig. 2.
For example : C:\170X4.
Step 2 : Copy ISP Software (170X4.zip) into your folder as
shown in Fig.2.
Step 3 : Unzip isp.zip into your folder as shown in Fig. 2.
Step 4 : Connect ISP cable and Mains cord to Monitor
as shown in Fig. 3.
Monitor (A)
Connect to
Mains cord
Video cable
Fig.3
ISP CABLE for CPU GM5120BD
is provided by Genesis to upgrade
Fig. 1
Fig. 2
Monitor (B)
PC
D-Sub
25 pins
ISP cable
Connect to Mains cord
at this moment.
Step 5 : Execute ISP Software in Monitor (A) as shown in Fig. 4.
Step 5-1.=> C:\cd 170X4 ( as shown in Fig. 4-1).
Press "Enter" key on keyboard, bring up Fig. 4-2.
Step 5-2.=> Key in "Gdd" Press "Enter" key on keyboard, bring up Fig. 4-3.
Step 5-3.=> Key in "BDISP.txt" ,Press "Enter" key on keyboard again, bring up
Fig.4-4.
Step 5-4.=> Key in "exit" ,Press "Enter" key on keyboard again, bring up
Fig.4-5.
<== 4-1
<== 4-2
<== 4-3
-----------------
--------------------------
<== 4-5
It is have to Re-connecting the main code After Finished,
Step 6 :
And entering factory mode to check CPU version as shown
in Fig. 5.
HUDSON 170X4 V200
Fig. 5
Troubleshooting :
Monitor : Monitor is on (LED is green.), or off,
but no display (black)
1. Make sure to disconnect the mains cord at Monitor ,
then connect it again.
2. EEPROM size may be not correct.
170X4
Go to cover page
<== 4-4
Fig. 4
2003-09-23
27
Advertisement
Table of Contents
