Table of Contents
Advertisement
X 20
170X4
Go to cover page
General
DDC Data Re-programming
In case the DDC data memory IC or main EEPROM which storage all
factory settings were replaced due to a defect, the serial numbers have
Analog DDC IC, & EEPROM
to be re-programmed"
It is advised to re-soldered DDC IC and main EEPROM from the old
board onto the new board if circuit board have been replaced, in this
case the DDC data does not need to be re-programmed.
Additional information
Additional information about DDC (Display Data Channel) may be
obtained from Video Electronics Standards Association (VESA).
Extended Display Identification Data(EDID) information may be also
obtained from VESA.
System and equipment requirements
1.
An i486 (or above) personal computer or compatible.
2.
Microsoft operation system Windows 95/98 .
Y
ou have t
o Install the EDID_PORT_Tool under Win2000/XP . As
Fig. 1 .
A. Cody the "UserPort.sys" to C:\WINNT\system32\drivers(win2000)
B. Running " io.exe" everytime, Before you start to programming
edid data .
3.
EDID45.EXE program .
4.
A/D Alignment kits (3138 106 10079):
inclusion :
a. Alignment box x1 (as Fig. 2)
Fig. 2
Fig. 2
b. Printer cable x1
c. (D-Sub) to (D-Sub) cable x1
Note: The EDID45.EXE is a windows-based program, which cannot
be run in MS-DOS.
".
C:\WINDOWS\system32\drivers(winXP)
DDC Instructions
Note: The alignment box has already build-in a batteries socket for
batteries (5V)
using
remove four screws at the rear of box. Please do not forget that
remove batteries after programming. The energy of batteries can
only drive circuits for a short period of time.
DC 5V
Fig. 1
Fig. 1
Power
indicator
Pin assignment
A. 15-pin D-Sub Connector
Pin
Assignment
No.
1
Red video input
2
Green video input
3
Blue video input
Identical output -
4
connected to pin 10
5
Ground
6
Red video ground
7
Green video ground
8
Blue video ground
as power source. Pull out the socket by
To Printer port
To Monitor
D-sub cable
Pin
No.
9
10
11
12
13
14
15
Fig. 3
Fig. 3
Assignment
DDC +5V
Cable detect
Identical output -
connected to pin 10
Serial data line (SDA)
H. Sync / H+V
V. Sync
Data clock line (SCL)
Advertisement
Table of Contents
