Kenmore 796.3140* Use & Care Manual page 29

BEFORE CALLING FOR SERVICE (continued)
Control panel has powered off due to Washer will not operate
inactivity,
Washer is unplugged.
Water supply is turned off.
Controls are not set properly.
Lid is open
Washer not filling
properly
Circuit breaker/fuse is tripped/blown.
Control needs to be reset.
START/PAUSE was not pressed after a cycle
was set.
Extremely low water pressure.
Washer is too cold,
Filter clogged.
Inlet hoses may be kinked
Energy efficiency.
Insufficient water supply.
The washer lid is open.
Hot and cold inlet hoses are reversed.
Water level is too low.
This is normal. Pressthe POWER button to turn
the washer on.
Make sure cord is plugged securely into a
working outlet.
Turn both hot and cold faucets fully on.
Make sure the cycle was set correctly, close the
lid and press the START/PAUSEbutton.
The washer will not operate if the lid is open.
Close the lid and make sure that nothing is
caught under the lid preventing it from closing
completely.
Check house circuit breakers!fuses. Replace
fuses or reset breaker. The washer should be
on a dedicated branch circuit, The washer will
resume the cycle where it stopped once power
is restored.
Press the POWER button, then re-select the
desired cycle and press the START!PAUSE
button.
Pressthe POWER button then re-select the
desired cycle and press the START/PAUSE
button. The washer wil shut off if the START/
PAUSEbutton is not pressed within four minutes.
Check another faucet in the house to make sure
that household water pressure is adequate.
If the washer has been exposed to
temperatures below freezing for an extended
period of time, allow it to warm up before
pressing the POWER button. Otherwise, the
display will not come on.
Make sure the inlet filters on the fill valves
are not clogged. Refer to the filter cleaning
instructions.
Check that inlet hoses are not kinked or
clogged,
This is an energy-efficient washer. As a result,
the temperature settings for this washer may be
different than non-energy-efficient washers.
Make sure that both hot and cold water faucets
are turned on all the way.
he washer will not operate if the lid is open.
lose the lid and make sure that nothing is
caught under the lid preventing it from closing
completely
Check inlet hose connections. Make sure the hot
water supply is connected to the hot inlet valve,
and the cold water supply is connected to the
cold inlet valve.
This is a high efficiency washer. The water will
not normally cover the clothes. The fill level is
optimized for the wash motion to achieve the
best wash performance.
29