Table of Contents
Advertisement
The Installation Menu
The Installation menu is used for installing the projector.
Items
Image Flip
Installation Attitude Right Side Up/Upside Down/Front Up/Front Down/Link to Image
High Altitude
*2
Mode
*3 *4
V Keystone
*6 *7
Rid. digitale
Notes
*1: Select "Link to Image Flip" only for horizontal installation. Be sure to select "Front Up" or
"Front Down" for vertical installation, according to the installation direction of the projector.
(Refer to the figures.)
*2: When "High Altitude Mode" is set to "On," the speed of the fan increases, and the fan noise
becomes slightly louder.
*3: Since the Keystone adjustment is an electronic correction, the image may be deteriorated.
*4: For VPL-SW636C, if you perform keystone adjustment and use mouse mode, the position of the
Interactive Pen Device and the cursor may not match. In this case, perform calibration, again.
*5: If you select "H" or "V," the Interactive function is not available.
*6: Since Digital Shrink uses electronic correction, the image may deteriorate.
*7: If you press the ENTER button while adjusting with Digital Shrink, the projector switches to the
shift adjustment.
Item descriptions
HV/H/V/Off: Flips the projected image horizontally or vertically
according to the installation method.
Flip: Change the cooling setting to suit to the installation attitude. When
set to "Link to Image Flip," the cooling setting changes based on the setting
*1
of "Image Flip."
Continuing to use the wrong setting may affect
component reliability.
Right Side Up
Upside Down
Horizontal installation
On/Off: Set to "On" when using the projector at an altitude of 1,500 m or
higher. Continuing to use the wrong setting may affect component
reliability.
The higher the value, the narrower the top of the projected image. The
lower the value, the narrower the bottom.
Shrinks or adjusts the size of the projected image (Digital Shrink).
Rid. digitale: Adjusts the size of the projected image. If you set the value
to "0", the image is set to the original size. The shrinking rate is 100% to
90%.
Shift: Adjusts the position of the projected image. The adjustable range
varies from the shrinking rate.
*5
Front Down
Front Up
(Projects
(Projects
downward)
upward)
Vertical installation
The Installation Menu
33
Hide quick links:
Advertisement
Table of Contents
