Advertisement
4. Insert all excess wire through the right Handrail (51) and
down into the right Upright (1).
Attach the right Handrail (51) to the right Upright (1) with
two Upright Screws (50) and an Upright Washer (82). Be
sure to start both Screws before tightening either one,
and push on the heads of the Screws whilst tightening
them.
Position the Console Base (8) on the left and right
Handrails (51). Attach the Console with four Console
Screws (17).
5. Attach the Frame Guide (68) and two Frame Guide
Spacers (93) to the Frame (66) with two Latch Screws
(17). Be careful not to overtighten the Screws. Note: If
the Frame Guides hit the Upright, use only one Spacer.
Make sure the Latch closes over the Frame Guide when
in the storage position.
6. Remove the backing from the Adhesive Clip (16). Press
the Adhesive Clip onto the Rear Roller Endcap (86) in
the indicated location. Press the Allen Wrench (62) into
the Adhesive Clip.
Make sure that all parts are tightened before you use the
treadmill. Note: To protect the floor or carpet, place a
mat under the treadmill.
6
4
8
17
17
50
82
1
51
51
50
5
93
68
17
66
Thick
End
6
86
16
62
HOW TO LOWER THE TREADMILL FOR USE
1. Hold the upper end of the treadmill with your right hand as
shown. Using your left thumb, slide open the storage latch
and hold it open. Pivot the treadmill until the frame and
foot rail are past the storage latch.
2. Hold the treadmill firmly with both hands, and lower the
treadmill to the floor. To decrease the possibility of in-
jury, bend your legs and keep your back straight.
Storage
Latch
Opened
11
Advertisement
