After Ironing - Bosch Sensixx'x DA30 Operating Instructions Manual

5. vertical steam

See the leaflet sides
This can be used to remove creases from
hanging clothes, curtains etc.
1. Set the temperature control (12) to "max".
2. Hang article of clothing on a clothes hanger.
3. Operate the iron in a vertical position at a
distance of 10 cm / 4 in, and press the shot of
steam button [ ]
(2) repeatedly with pauses
of at least 5 seconds.
6. Ironing without steam

See the leaflet sides
This enables the iron to be used for dry
ironing.
Set steam regulator (3) to the
7. Drip protection *
DripStop

See the leaflet sides
lf the temperature is set too low, the steam is
automatically switched off to avoid dripping.
There may be an audible click when this occurs.
8. Spray

See the leaflet sides
This can be used to remove stubborn
wrinkles.
Do not use the spray function with silk.
9. "secure" auto shut-off
function *
secure

See the leaflet sides
The "secure" auto shut-off function switches
off the iron when it is left unattended, thus
increasing security and saving energy.
If your iron is equipped with "secure" function,
you can find the text "auto off" on handle.
1. Plug in the iron.
2. Initial heating up process: this function will
be inactive for the first two minutes in order
to give the appliance time to reach the set
temperature.
* Model dependent
position.
[ ]
3. The safety circuit will switch the appliance off
automatically and the pilot light (15*) will start
flashing in the following cases:
a
If the iron is not moved for 30 seconds
while resting on its soleplate or on its side.
b If the iron is not moved for 8 minutes while
in the upright position.
4. To reconnect the iron, just move it about
gently.
10. "SensorSecure" function *

See the leaflet sides
The "SensorSecure" function makes the iron
heat up only when the handle is gripped, and
stop heating when the handle is no longer
gripped. Thus, safety and saving energy get
increased.
If your iron is equipped with "SensorSecure"
function, you can find the text "SensorSecure" on
handle.
1. Plug in the iron.
2. "SensorSecure" light (16*) flashes when
the handle is not gripped, and will show a
continuous light when the handle is gripped.
3. If the iron handle is released for more
than 10 seconds, the iron will stop heating
automatically.
4. When the handle is gripped again, the iron will
start heating up again.
Initial heating up process: it is not necessary
to grip the handle until the iron heats up to the
set temperature. Once reached such
temperature, the pilot light (13*) goes off.

11. after ironing


See the leaflet sides
1. Switch the steam regulator (3) from
"max" and back again several times (self-
cleaning).
2. Empty the tank. Hold the iron with the point
down and shake lightly.
3. Store standing on the rear, not on the base.
4. Do not wrap the power cord (14) too tight!
to
[ ]
15
BOS CH