Storage - Brawn BGMF33 Operation And Maintenance Manual

th
3389 ~ 128 Avenue Holland, MI 49424
REPLACING PACKING, Cont.
FIGURE 4: Butt-Cut Joints
FIGURE 5: Diagonally-Cut Joints
MIXER NAMEPLATE
Copyright 2015 BRAWN Mixer, Inc.
BGMFSB-S
ERIES
www.BRAWNMIXER.com
O & M
PERATION
Phone: 616/399-5600 Fax 616/399-3084
Units shipped from Brawn Mixer, Inc. are intended to be
used within 30 days after receipt and presumed to be
stored indoors in a heated building. Store mixers as
packaged by the factory. If you intend storing units under
adverse conditions or for a long period of time, special
storage precautions will be necessary.
1. Store in a sheltered area away from chemical vapors or
steam.
2. Cover.
3. Do not store in sunlight or near high heat.
4. Spray oil on exposed shafts and seals. Remove oil on
start-up.
5. Rotate output shaft 360º every 3-4 weeks.
6. Mixers should not be stored near vibrating machinery
to avoid damage to the bearings.
7. If electric motors have been subjected to humid
conditions, check the insulation resistance between
phase and mass and between the different phases.
The resistance should not be less than 100
megohms. If the resistance is less, please consult
the factory.
8/6/2015
M
AINTENANCE

STORAGE

ANUAL
Page 10 of 11