Advertisement
Start up Mist Generator :
Starting up Mist Generator
under a water feature :
Connect Mist Generator to
transformer :
6
7
Insert battery in remote
control :
v Place Mist Generator in water. (The Mist Generator can
be fixed in place with the 3 lugs
of the pond.)
3
For special light and mist effects the Mist Generator can also
be installed under a water feature.
1. Remove cover
2. Position the Mist Generator in the water over the water
feature pipe. If necessary, unscrew the water feature nozzle.
4
3. Connect Mist Generator to transformer (see below).
4. Adjust the water feature so that the water exiting does not
directly strike the mist membranes (impairment of Mist
Generator effect).
1. Set up transformer at a dry location protected from flooding
(The transformer can be screwed to a firm base using the
5
holes
2. Fit the connecting cable of the Mist Generator to the trans-
former connection
connection
3. Switch on Mist Generator :
See 4. Operation "Log on remote control to Mist
Generator" .
5
1. Open battery cover
2. Insert 12 V battery supplied
correct polarity).
8
3. Close battery cover
9
4
.
(∅ 4 mm)).
6
and screw the sleeve nut
6
.
8
.
9
(23 A type L 1028) (ensure
8
again.
3
using cords at the edge
7
onto the
13
Advertisement
