Filling With Oil; Assembling And Dismantling The Two-Piece Shaft; Fitting The Impact Guard - Husqvarna 525P4S Operator's Manual

Filling with oil

• Open the cap on top of the bar head
• Fill with Husqvarna saw chain oil.
• Refit the cap.
Assembling and dismantling the
two-piece shaft
525P5S
Assembly:
• Loosen the coupling by turning the knob counter-
clockwise.
• Align the tab of the attachment (A) with the arrow on
the coupling (B).
B
• Push the attachment into the coupling until the
attachment snaps into place.
16 – English
ASSEMBLY
A
• Before using the unit, tighten the knob securely.
Dismantling:
Loosen the coupling by turning the knob (at least 3 times).
• Push and hold the button (C). While securely holding
the engine end, pull the attachment straight out of the
coupling.
C

Fitting the impact guard

Fit the guard with three screws. Tighten the screws to 30
ft/lbs. (4 Nm). After the machine has been in use for
around 20 hours, re-tighten the screws to 4 Nm.