Cautions / Warnings; Package Contents; Important Parts - DeVilbiss DV6WM Instruction Manual

CAUTIONS / WARNINGS

• Use only chargers and charging
cables provided by DeVilbiss for use
with the DV6WM Wireless Modem.
Use of other chargers or charging
cables may result in malfunction or
damage to the DV6WM Wireless
Modem.
For storage and handling – The
following conditions may cause a fire
hazard by causing a failure of the
internal rechargeable battery:
• Never attempt to charge a Wireless
Modem with physical damage.
• If Wireless Modem temperature
exceeds 50˚C (122˚F), terminate
charging.
• Do not heat or throw Wireless
Modem into a fire.
• Do not use or store Wireless Modem
close to fire or inside the car where
temperature may be over 60˚C.
• Do not immerse the Wireless Modem
in water.
EN - 4

PACKAGE CONTENTS

DV6WM Wireless USB Wall
Modem Charger

IMPORTANT PARTS

Wireless Modem – Control Panel
Cell Phone
Bluetooth (link to CPAP)
(link to server)
Test Call button
Press to confirm LEDs illuminate
Normal Operation
The battery LED flashes when battery is low, otherwise all LEDs remain OFF except during call
sequence. During the call, the battery LED illuminates solid and either Bluetooth or Cell LEDs are
also active. You may not see this happen.
Call frequency has been preset by your provider.
NOTE: When battery LED flashes, refer to Charging the Modem Battery.
NOTE: To check operation at any time, press the test call button and confirm LEDs illuminate.
Instruction Guide
Battery charging
Battery
connector (USB)
DV6WM-122 Rev. C
Reset (do not press unless
instructed by your provider)
SE-DV6WM-1