Engine Coolant Check; Power Steering Fluid Check - Ford Ranger Owner's Handbook Manual

ENGINE COOLANT CHECK

Checking the coolant level
E79043
CAUTION
Make sure that the coolant level is
between the FULL and the LOW
marks.
Note: Coolant expands when it is hot.
The level may therefore extend beyond
the FULL mark.
Topping up the coolant
WARNING
Do not remove the coolant reservoir
cap when the engine is hot. Wait for
the engine to cool down.
Remove the cap slowly. Any pressure
will escape slowly as you remove the cap.
WARNINGS
Only add coolant when the engine
is cold. If the engine is hot, wait 10
minutes for the engine to cool
down.
Maintenance
plenty of water and contact your doctor.
Do not spill coolant on any part of the
engine.
Only add coolant that meets the Ford
specification. See Technical
specifications (page 99).
POWER STEERING FLUID
CHECK
plenty of water and contact your doctor.
Make sure that the level is between
the MIN and the MAX marks.
If the level is at the MIN mark, top up
immediately.
Topping up
Remove the filler cap.
Do not top up further than the MAX
mark.
Top up with fluid that meets the Ford
specification. See Technical
specifications (page 99).
97
WARNINGS
Do not allow coolant to touch your
skin or eyes. If this happens, rinse
the affected areas immediately with
CAUTION
WARNING
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse
the affected areas immediately with
CAUTION
CAUTION