Reconyx MicroFire User Manual page 10

TIP: When setting the camera up it's best to position the camera using the
"Check View" feature. The camera will send you a photo on demand to allow you
to see the camera's field of view.
NOTE: All RECONYX™ cameras will self-arm from the WalkTest mode after a
two minute period during which it does not detect any motion events.
External Power Connection
All MicroFire cameras include an External Power Connector and Cable. This
allows you to connect the Camera to a 12 volt DC 4 amp power supply of your
choosing. Connecting to the correct power supply is your responsibility! Any
damage caused by connecting to an incorrect power source is not covered under
the warranty. If you have any questions, please contact our Technical Service
department support@reconyx.com.
9 ©RECONYX, Inc.