Timer Operation; Power Saving Mode - Toshiba RAV-SM2242DT-E Owner's Manual

5

Timer operation

• Three timer modes are available: (Setting of up to 168 hours is enabled.)
Off timer : The unit stops when the set time is reached.
Repeat Off timer : The unit stops daily when the set time is reached.
On timer : The unit starts when the set time is reached.
1
3
Set
1
Push button.
The timer mode changes with every push of the
button.
Off Off On
(Off timer) (Repeat Off timer) (On timer)
No display
• and timer display flashes.
2
Push to select "set time".
• With every push of button, the set time
increases by 0.5 hr (30 minutes).
When setting a time more than 24 hours for
timer operation, timer can be set in increments
of 1 hr.
The maximum set time is 168hr (7 days).
The remote control displays the set time with
time (between 0.5 and 23.5 hours) (*
number of days and time (24 hours or more) (*
as shown below.
• With every push of button, the set time
decreases by 0.5 hr (30 minutes) (0.5 -
23.5 hours) or 1 hr (24 - 168 hours).
Example of remote control display
• 23.5 hours (* 1 )
2
• 34 hours (* )
Number of days Time
shows 1 day (24 hours).
shows 10 hours. (Total 34 hours)
13-EN
2
4
3
Push button.
icon disappears and time display goes on,
and or icon flashes.
(When On timer is activated, time and On timer
are icons and other icons disappear.)
4
Cancel timer operation
Push button.
Timer icon disappears.
NOTE
• When the operation stops after the timer reached the
preset time, the Repeat Off timer resumes the
operation by pushing button and stops the
operation after the time of the timer has reached the
set time.
• When you push while the Off timer function of
the air conditioner is active, the indication of the timer
function disappears and then appears again after
about 5 seconds.
This is due to normal processing of the remote
controller.
1 ) or
2 )
– 7 –
6

Power saving mode

The power saving mode saves energy by limiting the maximum current which will effect heating or cooling capacity
that the unit can generate.
Push button during operation.
• The air conditioner enters power saving mode.
• appears on the display.
Power saving mode will stay in effect until it is cancelled.
To cancel the power saving mode, push
• disappears.
NOTE
• When other electric appliances are used at the same time, to avoid triggering the circuit breaker, power saving mode
is recommended. Of course you can use power saving mode to save energy as well.
• Power saving mode consumes less energy, but may not heat / cool the room as much as normal mode. (The
maximum current is limited to approximately 75 % (factory default) of the normal mode.)
• To adjust the power-save settings, see "Power saving mode" in Advanced settings.
• Even when operation start / stop, operation mode change, or power reset is performed during the power saving mode,
the power saving mode is retained until the next operation.
button again.
14-EN