Maintenance; Gear Housing; Cleaning And Lubrication; Maintenance Schedule - Husqvarna HA110 Operator's Manual

Hide thumbs Also See for HA110:
Table of Contents

Advertisement

Gear housing

There is a grease nipple and a plug for filling lubricant on the
gear housing. Use a grease gun to fill with grease. New
machines are first filled with grease after approximately 20
hours of operation, and subsequently approximately every 60
hours of operation. Use Husqvarna's special grease, no.
503 98 96-01.
CAUTION! The gear housing must not be filled completely
with grease. The grease expands as the machine heats up
during operation. If the gear housing was completely filled
with grease it could damage the seals and lead to leakage of
grease.
The grease in the bevel gear does not normally need to be
changed except if repairs are carried out.

Cleaning and lubrication

Clean any resin and plant residue from the blades using
cleaning agent 531 00 75-13 (UL22) before and after using
the machine.
Lubricate the blade bars with special grease, part no. 531 00
75-12 (UL 21) before long periods of storage.
10 –
English

MAINTENANCE

Maintenance schedule

Below you will find some general maintenance instructions. If
you need further information please contact your service
workshop.
Daily maintenance
1
1 Check that the blades do not move when the engine is
idling or when the choke is in the start throttle position.
2 Check that the hand guard is not damaged. Replace the
guard if damaged. (HA 110)
Weekly maintenance
1
1 Fill the gear housing with grease. New machines are first
filled with grease after approximately 20 hours of
operation, and subsequently approximately every 60
hours of operation.
2 Check that the screws that hold the blades together are
correctly tightened.

Technical data

Technical data
Weight
Weight, Lbs/kg
Blades
Length, mm
Blade speed, cuts/min
2
2
HA 110
HA 850
2,0
2,4
550
550
4184
4184

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ha 850

Table of Contents