Built-in power bank with usb outlet to charge mobile devices (32 pages)
Summary of Contents for Husqvarna HA 110
Operator′s manual Manual d’utilisation Manual de instrucciones Hedge Trimmer Attachment HA 110 HA 850 Complément Taille-haie HA 110 HA 850 Tijeras cortasetos (suplemento) HA 110 HA 850 E E E E n n n n g g g g l l l l i i i i s s s s h h h h...
Symbols WARNING! Incorrect or careless use of a hedge trimmer can turn it into a dangerous tool that can cause serious or even fatal injury. It is extremely important that you read and understand the contents of this operator’s manual.
What is what on the hedge trimmer attachment? (HA 110)... What is what on the hedge trimmer attachment? (HA 850)... ASSEMBLY Fitting the hand guard and loop handle (HA 110) ... Fitting the cutting head ... STARTING AND STOPPING Check before starting ... MAINTENANCE Gear housing ...
Carry out the inspection, maintenance and service routines listed in this section. Hand guard (HA 110) The hand guard prevents hands from coming into contact with the moving blades, for example, if the operator loses grip on the front handle.
SAFETY INSTRUCTIONS Blade guard (HA 110) • Check that the blade guard is not damaged or distorted. • Replace the blade guard if it is bent or damaged. Gear housing • The gear housing gets hot when the machine has been in use.
• Do not rush the work, but work steadily until all the branches have been cut back cleanly. Changing the hedge trimmer angle (HA 110) • Undo the knob. • Press the cutting head against the ground or some other solid object until the desired angle has been obtained.
What is what on the hedge trimmer attachment? (HA 110) 1 Cutter 2 Grease nipples (3) 3 Bevel gear 4 Blade guard 5 Front handle 6 Hand guard mounting screw WHAT IS WHAT? 7 Angle adjustment knob 8 Hand guard 9 Operator′s manual...
What is what on the hedge trimmer attachment? (HA 850) 1 Cutter 2 Grease nipples (3) 3 Bevel gear 4 Front handle 5 Shaft (829 mm) 8 – English WHAT IS WHAT? 6 Angle adjustment knob 7 Operator′s manual 8 Transport guard...
7 Fit the clutch sleeve and tighten the two mounting bolts. ASSEMBLY Fitting the cutting head It is important that the hedge trimmer is laid on a ﬂat surface when you ﬁt the cutting head. Otherwise the cutting head may not be ﬁtted straight.
Check that the blade guard is not damaged or distorted. (HA 110) • Replace the blade guard if it is bent or damaged. (HA 110) • Make sure the gear housing is lubricated correctly. See instructions under the heading Gear housing.
There are three grease nipples on the gear housing. Use a grease gun to top up with grease. This should be carried out approximately every 20 working hours. Use Husqvarna special grease, part no. 503 98 96-01. CAUTION! The gear housing must not be ﬁlled completely with grease.