Speedrooter 91™
Specific Safety Information
1. Wear leather gloves provided with the
machine. Never grasp a rotating cable with
a rag or cloth glove. Could become wrapped
around cable and cause serious injury.
2. Never operate machine with belt guard
removed. Fingers can get caught between belt
and pulley.
3. Do not overstress cables.
hand on the cable for control when machine
is running. Overstressing cables because of
an obstruction may cause twisting, kinking, or
breaking of the cable and may result in serious
injury.
4. Position machine within two feet of drain
opening. Greater distances can result in cable
twisting or kinking.
5. Machine
is
designed
operation. Operator must control foot switch
and cable.
6. Do not operate machine in reverse (REV).
Operating machine in reverse can result in
cable damage and is used only to back cutting
tool out of an obstruction.
7. Keep hands away from rotating drum and
distributor tube.
unless machine is unplugged. Hand may be
caught in the moving parts resulting in serious
injury.
8. Be careful when cleaning drains where
cleaning chemicals have been used. Avoid
direct contact with skin and eyes.
cleaning chemicals can cause serious burns as
well as damage the cable.
9. Do not operate machine if operator or
machine is standing in water. Will increase
risk of electrical shock.
10. Wear safety glasses and rubber soled, non-
slip shoes. Use of this safety equipment may
prevent serious injury.
11. Before starting each job, check that the
cable in the drum is not broken or kinked, by
pulling the cable out and checking for wear
or breakage. Always replace worn out (kinked
or broken) cables with genuine GENERAL
replacement cables.
Keep gloved
for
one-person
Do not reach into drum
12. Only use this tool in the application for
which
instructions on the proper use of the
machine. Other uses or modifying the drain
cleaner for other applications may increase risk
of injury.
Ground Fault Circuit Interrupter
Your machine is equipped with a ground fault circuit
interrupter, which protects you against shock if a
short circuit should occur. Check that receptacle is
properly grounded. Test the GFCI before each use.
1. Plug into 120-volt receptacle.
2. Push test button. Indicator light will go out and
power to machine should cut off.
3. If light does not go out when test button is
pushed, equipment should not be used until
proper repairs can be made.
4. To restore power after test, push reset button.
With the reset button depressed, if the machine
doesn't start, stops while running, or if the
operator experiences a mild shock, do not use
the machine! Take it to a motor repair center or
return it to the factory for repairs.
Truck Loading Wheel
Drain
One person can easily load the Speedrooter 91
onto a truck. The swept-back handle and loading
wheel give you the needed leverage.
4
it
was
designed.
Note: The section of cord between
the wall plug and the GFCI is not in
the protected circuit.
Follow
the
(GFCI)
Need help?
Do you have a question about the speedrooter 91 and is the answer not in the manual?
Questions and answers
What's the price