Advertisement
5.5.
Slide the inner cable through the slot.
See Figure 5.5.
Figure 5.5
5.6.
Unhook the Z-fitting from the blade brake and
discard the old cable.
5.7.
Install in reverse order.
NOTE: The only adjustment on this cable is
moving the Z-fitting from on hole to another on
the safety bail.
5.8.
Test run the mower before returning it to service.
Slot
7
6.
TRACTION CONTROL CABLE
6.1.
Disconnect the spark plug wire and ground it to
an engine bolt.
6.2.
Take measures to prevent fuel from leaking from
the gas tank.
6.3.
Remove the blade as described in blade
removal section.
6.4.
Remove the wheels and shroud as described in
the belt removal section.
6.5.
Unhook the Z-fitting from the Idler bracket.
See Figure 6.5.
Unhook the
Z-fitting
Figure 6.5
6.6.
Squeeze the tabs together on the cable jacket,
using a pair of pliers or a ford fuel line discon-
nect tool, and push it through the bracket.
See Figure 6.6.
Squeeze tabs together
Figure 6.6
6.7.
slide cable out of the deck.
Self-Propelled Mower
Hide quick links:
Advertisement
