Table of Contents
Advertisement
S4 Tech Inc
Plug the RJ-45 connector into the female RJ-45 receptacle inside the waterproof connector as shown in
Figure 15. Make sure that the RJ-45 tab lines up with the connector tab hole and that it snaps into
place inside the receptacle. Once this is done, screw the watertight connector cover back on and
tighten. Then strain relieve the CAT-5 cable by tightening the lower nut until the cable is snug inside
the connector.
Figure 13: Complete CAT-5 Camera Connection
Back at the DVR station, the CAT-5 cable for that camera can now be plugged into the VPD in the
corresponding channel.
*** WARNING*** IN ORDER TO PREVENT CAPACITIVE OVERLOADING OF THE POWER
SUPPLY, IT IS RECOMMENDED TO PLUG THE VIDEO CABLES INTO THE VPD ONE AT A
TIME WHILE THE VPD IS ALREADY POWERED UP. THIS IS ESPECIALLY IMPORTANT IF
THE CAT-5 CABLES ARE SHORTER THAN A FEW HUNDRED FEET.
Connecting the Cameras to the Mobile DOG Base Station
Once the cameras have been connected to their respective CAT-5 cables, it is time to connect them to
the Mobile DOG Base Station. It is recommended to have the Base Station powered up as described
above and to plug each camera one at a time; this eliminates any potential power surge associated with
powering everything up at once.
11
Advertisement
Table of Contents
