Adjusting The Harness And Brush Cutter; Standard Harness; Triobalance Harness - Husqvarna 333R Operator's Manual

Adjusting the harness and brush
cutter
WARNING! When using a brush cutter it
!
must always be hooked securely to the
harness. Otherwise you will be unable to
control the brush cutter safely and this
can result in injury to yourself or others.
Never use a harness with a defective
quick release.

Standard harness

Quick release
At the front is an easily accessible, quick release. Use this
if the engine catches fire or in any other emergency
situation that requires you to free yourself from the
machine and harness.
Spreading the load on your shoulders
A well-adjusted harness and machine makes work much
easier. Adjust the harness for the best working position.
Tension the side straps so that the weight is evenly
distributed across both shoulders.
Correct height
1 Forestry clearing
The machine should be supported in a harness when
forestry clearing so that the cutting equipment is angled
slightly forwards in relation to the ground. Adjust the
16 – English
ASSEMBLY
height using the strap on the harness for the support
hook.
2 Grass clearing
The machine should be supported in a harness when
grass clearing so that the cutting equipment is parallel to
the ground.

Triobalance harness

Quick release
Push down the red release lever to release the machine
from the harness.
Adjusting the harness
1 Tighten the hip strap so that it sits securely.