Stopping The Engine; Drive Disengagement Lever - Husqvarna Rider 11 Operator's Manual

WARNING!
Never drive the machine on
ground with a slope of more
than 15°. Mow slopes upwards
and downwards, never across.
Avoid sudden changes in
direction.
Hill start, manual gearbox
1. Press down the parking brake.
2. Push the throttle control to full throttle position.
3. Push down the clutch and engage first gear.
4. Carefully release the clutch.
5. When the engine starts to pull, release the
parking brake.

Stopping the engine

Preferably allow the engine to idle for a minute to
obtain normal working temperature before stopping
it if it has been working hard.
1. Lift up the cutting unit by pulling the lever back to
the end position.
2. Rider 11 and Rider 11 Bio: Pull back the
throttle control and put the gear lever into neutral
"N" without pressing the reverse lock button.
Turn the ignition key to the "STOP" position.
Rider 13 and Rider 13 Bio: Pull back the
throttle lever and turn the ignition key to the
"STOP" position.
3. When the rider mower is stationary, hold down
the parking brake and push in the lock button.
Release lever Rider 13 and Rider 13 Bio
In order to move the machine when the engine is
switched off the release lever must be pressed
down and forwards.
20
– English
DRIVING
MAX 15°
STOP START
6007-013
6007-014H
6007-015
8009-574