Dry Pick Up - Black & Decker HSVJ415JMBF Instruction Manual

Dry pick up

• For everyday spills of dry material.
• Do not fill the dust bowl (8) beyond the
end of the intake chute.
Optimizing the suction force
In order to keep the suction force optimised,
the filters must be cleared regularly during use.
EMPTYING AND CLEANING
THE PRODUCT
Removing the dust bowl and
filters - Figures L & M
WARNING:
and should be cleaned regularly.
• Press the dust bowl release button (9) as
shown in the insert of Figure L, then pull
the dust bowl (8) straight off as shown in
Figure L.
L
• While holding the dust bowl over a bin or
sink, pull out the filter (20) to empty the
contents as shown in Figure M.
M
• To replace the dust bowl, push it back onto
the appliance until it clicks firmly into place.
WARNING:
without the filters. Optimum dust collection
will only be achieved with clean filters.
Cleaning the Dust Bowl and Filter
• The dust bowl and filter can be washed in
warm soapy water.
• Make sure the filter and the dust bowl are dry
before re-fitting.
The filters are reusable
20
Never use the appliance
For a more thorough cleaning
• Remove the dust bowl and filter assembly
as described above.
• To separate the plastic filter (21) from the
cloth filter (22), twist the plastic filter in a
counterclockwise direction and lift it off of
the cloth filter as shown in Figure N.
• Shake or lightly brush any loose dust off
both filters.
N
• The dust bowls and filters can be washed
in warm soapy water. Allow to dry before
placing back into the vac.
• To replace the filters, slide the outer
plastic filter over the cloth filter.
• Align the wings of the plastic filter with
the slots in the cloth filter and twist in a
clockwise direction.
• Place filters back into the bowl pressing
firmly to ensure a secure fit.
• To replace dust bowl, place it back onto the
handle until it "clicks" firmly into position.
IMPORTANT: Maximum dust collection
will only be obtained with a clean filter and
an empty dust bowl. If dust begins to fall
back out of the product after it is switched
off, this indicates that the bowl is full and
requires emptying.
• Wash the filters regularly using warm,
soapy water and ensure that they are
completely dry before using again. The
cleaner the filter is, the better the product
will perform.
• It is very important that the filter is
correctly in position before use.
Scented filter
BEFORE FIRST USE - remove bag from
the scented pre-filter. Reassemble per
instructions above.
When the vacuum is turned on, the plastic
scented filter will emit an aroma to freshen
the air.
WARNING:
· Causes mild skin irritation
· Toxic to aquatic life
· Harmful to aquatic life with long lasting
effects.
· Dispose of contents/ containers to an
6
22
21