Roadstar KID-55CD Instruction Manual page 5

• Insert an audio CD with
the printed side facing out.
• Close the CD door.
• Press PLAY/PAUSE to start playing.
• To pause playing press PLAY/PAUSE, press PLAY/PAUSE again to resume playing.
• To stop CD playing, press STOP.
Selecting a different track
Press SKIP/SEARCH once or repeatedly until the desired track number appears in
the LED DISPLAY
Finding a section I interval within a track
• Press and hold down SKIP/SEARCH.
• When you recognize the passage / interval you want, release SKIP/SEARCH in
order to continue playing.
Repeat playing
• To repeat the current track, press REPEAT once and the REPEAT INDICATOR will
flash.
• To repeat the entire CD/program, press REPEAT again and the REPEAT INDICATOR
will light up. To return to normal playing, press REPEAT again.
Programming track numbers
Program in the stop status to select and store your CD tracks in the desired sequence.
Up to 20 tracks can be stored in the memory.
5
English
6
English
• Press PROGRAM to start.
• Use the SKIP/SEARCH to select your desired track number.
• Press PROGRAM to store.
• Repeat the above two steps to select and store all desired tracks.
• Press PLAY/PAUSE to start playing your CD program.
Reviewing the program
In the stop status, press PROGRAM repeatedly, the LED DISPLAY shows the track
numbers you stored in sequence.
Erasing a program
• You can erase the program by pressing STOP once in the program status or by
pressing STOP twice in the program playing status.
Use of Microphone with / without CD playing
• Switch microphones to the ON position.
• Adjust the volume to the desired level by tuning MIC VOLUME.
• Speak or sing in normal voice about 1 inch from microphone.
Using headphones (not included)
• Connect the headphones into the HEADPHONES jack on the CD player.
• Adjust the volume to the desired level by tuning POWER ON/OFF / MUSIC VOLUME.
CAUTION
• Abnormal operation may occur when the batteries become weak (The symbol "no"
will be found in the LED display). For normal operation, please always use new
batteries and replace the exhausted batteries
• Feed back may occur when the microphones placed too close to the player. It is
necessary to move the microphones appropriately away from the player body.
• Old and new or different type of batteries should not be used in combination.
• Remove batteries if they are exhausted or if the set will not be used for a long time.
• Do not touch the lens of the CD player.
• Do not attempt to disassemble the CD player as laser rays from the optical pickup
are dangerous to the eyes.
• Do not expose the set, batteries of CDs to humidity, rain, sand or overheating.
• Do not play with your earphones at a high volume.
• Always press STOP button to make sure the unit is completely stopped before
turning "POWER ON/OFF", anti-clockwise to turn off.
• Do not attempt to open the CD door during CD playing.
• Always keep the CD door closed to prevent the lens from contamination by dust.
immediately.