Brake Light Switches - Yamaha GRIZZLY 350 YFM35GA Owner's Manual

1. Locknut
2. Brake lever free play adjusting bolt
d. Tighten the locknut at the brake lever.
TIP
8
When adjusting the rear brake lever free play:
G
Be sure not to step on the brake pedal.
G
Make sure the brake pedal does not move.
3. Checking the brake pedal height
The top of the brake pedal should be posi-
tioned 72.0–82.0 mm (2.83–3.23 in) above
the footboard bracket. If the brake pedal
height is incorrect, have a Yamaha dealer ad-
just it.
1 2 (a)
(b)
1. Distance between brake pedal and footboard bracket
EBU24754

Brake light switches

The brake light, which is activated by the brake
pedal and brake levers, should come on just be-
fore braking takes effect.
The brake light switch for the brake pedal can be
adjusted as follows, but the other brake light
switches should be adjusted by a Yamaha dealer.
8-32
1 1
1. Remove panel A. (See page 8-9.)
2. Turn the brake light switch adjusting nut while
holding the brake light switch in place. To
make the brake light come on earlier, turn the
adjusting nut in direction (a). To make the
brake light come on later, turn the adjusting
nut in direction (b).