Bosch GWS 14,4 V Operating Instructions Manual page 9

1 609 929 L70 - USA Seite 9 Donnerstag, 12. Juli 2007 2:21 14
When using the rubber sanding pad 9, remove the
protection guard 6 if required by the application.
– Place the grinding disc onto the centering col-
lar 11. Rotate the grinding disc until the
notches of the grinding disc coincide with the
cams 12 of the centering collar 11. The grind-
ing disc drops into the tool holder.
11
12
– Rotate the grinding disc in clockwise direction
applying pressure, until the grinding disc can
be heard to engage ("click").
12 13
Disassembly
– Press and hold the SDS-pro release button 14.
At the same time, rotate the grinding disc in
counterclockwise direction.
– Let go of the SDS-pro release button 14 and
remove the grinding disc.
1 609 929 L70 • 12.7.07
Inserting the Battery
Push the charged battery 1 into the handle until
you feel it catching.
Switching On and Off
To start the tool, press the On/Off switch 3 for-
ward.
To lock-on, press the On/Off switch 3 down at
the front until it engages.
To switch off the machine, release the On/Off
switch 3 or press the rear tip of it down.
The grinding disc is
clamped correctly
when the 3 locking
fixtures 13 and the
3 cams 12 project
over the steel sheet
hub of the disc. The
grinding disc must be
free to turn.
14
Initial Operation
Use only original Bosch O-pack batteries with
the voltage given on the type plate of your ma-
chine.
Before inserting the battery and for a tool
change, always switch the On/Off switch to the
Off position. Remove the battery for transpor-
tation and storage.
Operating Instructions
The machine may not be clamped into a
grinder stand.
Make sure that the workpiece is firmly po-
sitioned and cannot move while working it.
In order to achieve optimum working
progress, an extreme drop in speed is to be
avoided. High stock removal occurs when
heavy sparking is given.
English | 9