Brake Light Switches; Checking And Lubricating The Cables - Yamaha GRIZZLY 350 YFM35FGIA Owner's Manual

EBU24755

Brake light switches

The brake light, which is activated by the brake
pedal and brake levers, should come on just be-
fore braking takes effect.
The rear brake light switch for the brake pedal can
be adjusted as follows, but the other brake light
switches should be adjusted by a Yamaha dealer.
1. Remove panel A. (See page 8-9.)
2. Turn the rear brake light switch adjusting nut
while holding the brake light switch in place.
To make the brake light come on earlier, turn
the adjusting nut in direction (a). To make the
brake light come on later, turn the adjusting
nut in direction (b).
8
1. Rear brake light switch
2. Rear brake light switch adjusting nut
3. Install the panel.
EBU24901

Checking and lubricating the cables

The operation and the condition of all control ca-
bles should be checked before each ride, and the
cables and cable ends should be lubricated if nec-
essary. If a cable is damaged or does not move
smoothly, have a Yamaha dealer check or replace
it.
Recommended lubricant:
Engine oil
8-37