JK Audio BLUEPACK User Manual page 19

Why is the peak LED still red
after I turned down the mic
volume level?
The microphone and Aux Send are
a combined input. If you see this red
LED flashing, you should decrease
the Mic and/or Aux Send input levels
until the combined input is no longer
clipping.
My BluePack won't pair with my
cell phone. Why won't it accept
the PIN?
If this is the first time you have paired
the BluePack with this cell phone,
make certain you are in Pairing Mode
and not Idle Mode. You must hold the
MFB in for approximately 6 seconds to
reach Pairing Mode the first time you
connect.
Can I have full duplex stereo
conversations if my stereo
headset uses A2DP?
No, the A2DP profile is only used for
stereo music streaming. Full duplex
conversations will be in mono.
FAQs
13
FAQs