Assembly Instructions - Husqvarna Master 46 Operator's Manual

A1
Product Number . . . . . . . . . . . . . . . . . .
Model Number . . . . . . . . . . . . . . . . . . .
Serial Number. . . . . . . . . . . . . . . . . . . .
Date of Purchase . . . . . . . . . . . . . . . . .
Place of Purchase. . . . . . . . . . . . . . . . .
•PLEASE KEEP PROOF OF PURCHASE•
1. Set the lower handlebar in place. (B1)
2. Insert the plastic plugs on both sides. (B2)
3. Assemble the upper handle. Note: washer
between wing nut and handle. (B3)
Handlebar Stop
• THE 2 HANDLEBAR STOPS MUST BE
FITTED BEFORE USE
1. In the packaging you will find 2 stops one
marked -H- and one marked -V-.
2. To lock the handlebar in a fixed position,
attach the stops as shown in the illustration
(B4).
3. Place -H- on the right side and -V- on the
left side.
Recoil Starter
1. Disconnect the spark plug lead.
You must release the brake by pulling
the OPC lever to the handle before
pulling out the cord.
2. Pull the Operator Presence Control to
release the brake on the engine.(B5)
3. Extend the pull cord fully.
4. Locate the cord in the pull cord guide
positioned on handle (B6).
Filling with Oil
1. Fill the engine with oil. A bottle of the
correct amount of oil is included with the
mower, SAE 30.
ADJUSTING THE CUTTING HEIGHT
1. Remove the spark plug lead before
adjusting.
2. Move the axles between the notches to
achieve the desired cutting height. (C1) &
(C2)
ENGLISH - 3
PRODUCT RATING LABEL

ASSEMBLY INSTRUCTIONS

Your product is uniquely identified by a
silver and black product rating label. To
ensure you have full product information
when obtaining spares or advice from one
of our approved service centres or if you
need to contact our customer service
department you should make a note in the
space provided of the information shown in
Fig A1.
B1
B3
B5
C1
B2
B4
B6
C2