Timing Of Replacing The Lamp - JVC LX-FH50 User Manual

Timing of replacing the lamp

When the Lamp indicator lights up red or a message appears suggesting it is time to replace the
lamp, please install a new lamp or consult your dealer. An old lamp may cause a malfunction in
the projector and in some instances the lamp may explode.
The LAMP indicator light and TEMP warning light will light up if the lamp becomes too hot. Turn
the power off and let the projector cool for 45 minutes. If the LAMP or TEMP indicator still lights
up after turning the power back on, please contact your dealer. See
The following lamp warning displays will remind you to change the lamp.
The illustrations show below are for reference only and may differ from the actual design.
The lamp has been in operation for 1500 hours. Install a
new lamp for optimal performance. If the projector is
normally run with Economic selected (See
the lamp hour"), you may continue to operate the projector
until the 1950 hour lamp warning appears.
The lamp has been in operation for 1950 hours. A new lamp
should be fitted to avoid the inconvenience when the
projector runs out of lamp time.
The lamp has been in operation for 2000 hours.
It is strongly recommended that you replace the lamp at this
age.
The lamp is a consumable item. The lamp brightness
diminishes with use. This is normal lamp behavior. You
can replace the lamp whenever you notice that the
brightness level has significantly diminished. If the
lamp is not replaced beforehand, it must be replaced
after 2000 hours usage.
The lamp MUST be replaced before the projector will
operate normally.
40 Maintenance
Status
"Getting to know
"Indicators" for details.
Message
Notice
Order Replacement Lamp
Lamp>1500 Hours
Notice
Replace Lamp Soon
Lamp>1950 Hours
Notice
Replace Lamp Now
Lamp>2000 Hours
WARNING
Out of Lamp Usage Time
Replace lamp (Refer to user manual)
Then reset lamp timer