Door Reversibility - AEG S74010KDX0 User Manual

4. Tighten again the screws.
9.5 Levelling
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
9.6 Removing the shelf
holders
A
Your appliance is equipped with shelf re-
tainers that make it possible to secure
the shelves during transportation.
To remove them proceed as follows:
1. Move the shelf holders in the direc-
tion of the arrow (A).
2. Raise the shelf from the rear and
push it forward until it is freed (B).
3. Remove the retainers (C).
B
C

9.7 Door reversibility

To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the
doors of the appliance during
the operations.
To change the opening direction of the
door, do these steps:
• Remove the plug from the power
socket.
• Tilt back the appliance carefully so
that the compressor cannot touch the
floor.
• Remove the plinth (1).
• Remove the cap (2) and position it on
the opposite side.
• Unscrew the hinge (3) and remove the
door.
• Unscrew the lower pin and the wash-
ers (3)
• Position the pin and the washers (6) on
the opposite side (7).
• Unscrew the other hinge (5)
3
6
• Unscrew the upper pin (4) and screw it
on the opposite side. (5)
• Refit the door.
15
2
1
7
8